-
Recent Posts
Recent Comments
Archives
Categories
Meta
Author Archives: Ted Lowe
BBTC Form Factor and Safety
Progress from my last post: Abandoned “Arduino Shield” form factor because it was too small for 4 relays and had too much baggage, ie. unneeded electronics and connections. Redesigned circuit and PCB into an “Arduino clone” with isolated logic and … Continue reading
Posted in Uncategorized
Leave a comment
BBTC demo video and 4-box schematic and board layout
i’ve made good progress on the BBTC project since the first post. i breadboarded a proof-of-concept design with a single temperature sensor and used an incandescent light bulb to simulate a battery heater. Here’s a demo: i designed a 4-box … Continue reading
Posted in Uncategorized
Leave a comment
Creating An Arduino-based Battery Box Temperature Controller (BBTC)
Introduction This posts introduces the design of an open-source custom electronic device that will be used to monitor and control the temperature of up to four battery boxes. Background Electric vehicle range is greatly reduced by cold batteries and the … Continue reading
Posted in Uncategorized
Leave a comment
Hello world!
i am happy to be part of the new FVEAA Blog Network!
Posted in Uncategorized
Leave a comment
Check out my members page for now
i plan to move all the images and articles from my members page to this new blog format. In the meantime, please check out my stuff at http://tedlowe.fveaa.org
Posted in Uncategorized
Leave a comment